Calibration Report Measure stopped working
My calibration report only shows the actual and not the model electric. This feature was working just fine so I know it should still be working. Is there an edit to the OSM than can take me back to where can reload these. How do I remove the built in measure so that it can be reloaded. Is it possible that running PAT affected the script? Is there a file I can delete and reload or is an edit to the OSM needed. Sorry but I think there should be clearer controls that allow for this type of debug. It is a shame that one feels they need to become a programmer to successfully generate reports. Thank you, Matt
Comments
Do you see any simulation results in the standard report? I'm wondering if the simulation failed to run, that could result in th behaivor you ar describing.
Hi David, yes the model runs.
I believe the answer might have been covered elsewhere. The Sketchup GUI corrupts OS Measures. After running a model with added OS Measures you cannot alter anything with the Sketchup GUI or the .osm becomes corrupt and PAT will likewise fail.
Best Regards, Matt