Revision history [back]
Simulation failed with modified HVAC schedules
Before my modification, everything is normal, the simulation is smooth and the OpenStudio Results can be generated.
However, then I modified the setpoint schedules (cooling, heating, humidifying & dehumidifying). There were no complicate change, I just shortened the operation periods for the four schedules.
Then I ran the simulation and obtained the following figure.
Now even I change back the setpoint schedules, the simulation cannot go on.
Have anyone met this situation?
In addition, deleting the schedule and reinserting the schedules did not work.
Simulation failed with modified HVAC schedules
Before my modification, everything is normal, the simulation is smooth and the OpenStudio Results can be generated.
However, then I modified the setpoint schedules (cooling, heating, humidifying & dehumidifying). There were no complicate change, I just shortened the operation periods for the four schedules.
Then I ran the simulation and obtained the following figure.
Now even I change back the setpoint schedules, the simulation cannot go on.
Have anyone met this situation?
In addition, deleting the schedule and reinserting the schedules did not work.
Simulation failed with modified HVAC schedules
Before my modification, everything is normal, the simulation is smooth and the OpenStudio Results can be generated.
However, then I modified the setpoint schedules (cooling, heating, humidifying & dehumidifying). There were no complicate change, I just shortened the operation periods for the four schedules.
Then I ran the simulation and obtained the following figure.
Now even I change back the setpoint schedules, the simulation cannot go on.
Have anyone met this situation?
In addition, deleting the schedule and reinserting the schedules did not work.
Simulation failed with modified HVAC schedules
Before my modification, everything is normal, the simulation is smooth and the OpenStudio Results can be generated.
However, then I modified the setpoint schedules (cooling, heating, humidifying & dehumidifying). There were no complicate change, I just shortened the operation periods for the four schedules.
Then I ran the simulation and obtained the following figure.
Now even I change back the setpoint schedules, the simulation cannot go on.
Have anyone met this situation?
In addition, deleting the schedule and reinserting the schedules did not work.
Newest founding, I just save as and the file cannot run. It seems become another problem...
Simulation failed with modified HVAC schedules
Before my modification, everything is normal, the simulation is smooth and the OpenStudio Results can be generated.
However, then I modified the setpoint schedules (cooling, heating, humidifying & dehumidifying). There were no complicate change, I just shortened the operation periods for the four schedules.
Then I ran the simulation and obtained the following figure.
Now even I change back the setpoint schedules, the simulation cannot go on.
Have anyone met this situation?
In addition, deleting the schedule and reinserting the schedules did not work.
Newest founding, I just save as and the file cannot run. It seems become another problem...
Simulation failed with modified HVAC schedules
Before my modification, everything is normal, the simulation is smooth and the OpenStudio Results can be generated.
However, then I modified the setpoint schedules (cooling, heating, humidifying & dehumidifying). There were no complicate change, I just shortened the operation periods for the four schedules.
Then I ran the simulation and obtained the following figure.
Now even I change back the setpoint schedules, the simulation cannot go on.
Have anyone met this situation?
In addition, deleting the schedule and reinserting the schedules did not work.
Simulation failed with modified HVAC schedules
Before my modification, everything is normal, the simulation is smooth and the OpenStudio Results can be generated.
However, then I modified the setpoint schedules (cooling, heating, humidifying & dehumidifying). There were no complicate change, I just shortened the operation periods for the four schedules.
Then I ran the simulation and obtained the following figure.
Now even I change back the setpoint schedules, the simulation cannot go on.
Have anyone met this situation?