I'm trying to better understand how the VRF system is modeled. I'm using openstudio 3.3.0. I built a "Test Model" whos geometry is a simple two room floor plan, each room is its own thermal zone.

After placing the VRF system and the VRF Zone Terminal Units, I get the following error when running the simulation.

Fatal ** GetVRFInput: Errors found in getting AirConditioner:VariableRefrigerantFlow system input. Preceding condition(s) causes termination.

I went through and tried to enter information into the input fields that were blank, but the error persist.

I'm trying to better understand how the VRF system is modeled. I'm using openstudio 3.3.0. I built a "Test Model" whos geometry is a simple two room floor plan, each room is its own thermal zone.

After placing the VRF system and the VRF Zone Terminal Units, I get the following error when running the simulation.

Fatal ** GetVRFInput: Errors found in getting AirConditioner:VariableRefrigerantFlow system input. Preceding condition(s) causes termination.

I went through and tried to enter information into the input fields that were blank, but the error persist.