Hello everyone, Hope you are all well and in good health.

I'm wondering how can I change the set-point tolerance in energyplus. I mean by that the minimum or maximum temperature difference between an actual node temperature and the corresponding setpoint before a heating or cooling device would turn on or off. I Imagine it can be increased by an EMS but is there a way we can reduce it ?

May you all be safe in those times Thanks

Hello everyone, Hope you are all well and in good health.

I'm wondering how can I change the set-point tolerance in energyplus. I mean by that the minimum or maximum temperature difference between an actual node temperature and the corresponding setpoint before a heating or cooling device would turn on or off. I Imagine it can be increased by an EMS but is there a way we can reduce it ?off.

May you all be safe in those times Thanks