Hello All,

Is there any way to control the HW loop when using the PlantEquipmentOperation:Uncontrolled? From the documentation of EnergyPlus it says,

"If the loop runs, this equipment will run also, unless turned off by the loop flow resolver to maintain continuity in the fluid loop."

So, is there any way to run the loop, to have the equipment running?

PlantEquipmentOperationSchemes,
   HW Loop Operation,                                                                                  
   PlantEquipmentOperation:Uncontrolled,                                                      
   HW Loop Scheme 1,                                                                                  
   On 24/7;                                                                                            

PlantEquipmentOperation:Uncontrolled,
   HW Loop Scheme 1,                                                                            
   HW Loop Scheme 1 Equipment List;                                                     

PlantEquipmentList,
   HW Loop Scheme 1 Equipment List,                                                     
   Boiler:HotWater,                                                                                 
   Boiler;

I have a Heated Floor system with natural Ventilation (from Designbuilder), as shown in

Hello All,

Is there any way to control the HW loop when using the PlantEquipmentOperation:Uncontrolled? From the documentation of EnergyPlus it says,

"If the loop runs, this equipment will run also, unless turned off by the loop flow resolver to maintain continuity in the fluid loop."

So, is there any way to run the loop, to have the equipment running?

PlantEquipmentOperationSchemes,
   HW Loop Operation,                                                                                  
   PlantEquipmentOperation:Uncontrolled,                                                      
   HW Loop Scheme 1,                                                                                  
   On 24/7;                                                                                            

PlantEquipmentOperation:Uncontrolled,
   HW Loop Scheme 1,                                                                            
   HW Loop Scheme 1 Equipment List;                                                     

PlantEquipmentList,
   HW Loop Scheme 1 Equipment List,                                                     
   Boiler:HotWater,                                                                                 
   Boiler;

I have a Heated Floor system with natural Ventilation (from Designbuilder), as shown in HVAC System.png

Hello All,

Is there any way to control the HW loop when using the PlantEquipmentOperation:Uncontrolled? From the documentation of EnergyPlus it says,

"If the loop runs, this equipment will run also, unless turned off by the loop flow resolver to maintain continuity in the fluid loop."

So, is there any way to run the loop, to have the equipment running?

PlantEquipmentOperationSchemes,
   HW Loop Operation,                                                                                  
   PlantEquipmentOperation:Uncontrolled,                                                      
   HW Loop Scheme 1,                                                                                  
   On 24/7;                                                                                            

PlantEquipmentOperation:Uncontrolled,
   HW Loop Scheme 1,                                                                            
   HW Loop Scheme 1 Equipment List;                                                     

PlantEquipmentList,
   HW Loop Scheme 1 Equipment List,                                                     
   Boiler:HotWater,                                                                                 
   Boiler;

I have a Heated Floor system with natural Ventilation (from Designbuilder), as shown in HVAC System.png