Dear all, I 've been trying a single zone for HVAC analysis for a while, simulation always ends badly. The most and big problem shows" field [ xxx Inlet/outlet Node Name] is required but was blank, and I check a lot of discussion in the forum which is similar to this one. But unfortunately, even I delete extra setting coils still can't fix it out.

Could someone please kindly help me on this issue? I'll be appreciated!

Attached file here.

Borui

Dear all, I 've been trying a single zone for HVAC analysis for a while, simulation always ends badly. The most and big problem shows" field [ xxx Inlet/outlet Node Name] is required but was blank, and I check a lot of discussion in the forum which is similar to this one. But unfortunately, even I delete extra setting coils still can't fix it out.

Could someone please kindly help me on this issue? I'll be appreciated!

Attached file here.

Borui

Dear all, I 've been trying a single zone for HVAC analysis for a while, simulation always ends badly. The most and big problem shows" field [ xxx Inlet/outlet Node Name] is required but was blank, and I check a lot of discussion discussing in the forum which is similar to this one. But unfortunately, even I delete extra setting coils still can't fix it out.

Could someone please kindly help me on this issue? I'll be appreciated!

Attached file here.

BoruiBorui