I am using OpenStudio 1.11.1 and energyplus version is 8-5-0.

my building consists of single story with attic, and I am not using ideal load or HVAC system, after I run the simulation I get 26 errors:

19 errors due to surface matching even the sketchup didn't show any errors after surface matching: (I used matching tool and intersections for matching), however I noticed that all the errors are due to surface matching between the interior ceiling and the attic floor.

and 7 other errors as shown in following figure:

I am using OpenStudio 1.11.1 and energyplus version is 8-5-0.

my building consists of single story with attic, and I am not using ideal load or HVAC system, after I run the simulation I get 26 errors:

19 errors due to surface matching even the sketchup didn't show any errors after surface matching: (I used matching tool and intersections for matching), however I noticed that all the errors are due to surface matching between the interior ceiling and the attic floor.

and 7 other errors as shown in following figure:

I am using OpenStudio 1.11.1 openstudio and energyplus version is 8-5-0.

8-5-0 my building consists of single story with attic, and I i am not using ideal load or HVAC system, after I run the simulation I i get 26 errors:

errors: 19 errors due to surface matching even the sketchup didn't show any errors after surface matching: (I ( i used matching tool and intersections for matching), however I i noticed that all the errors are due to surface matching between the interior ceiling and the attic floor.

floor. C:\fakepath\2 error.JPG

and 7 other errors as shown in following figure:figure: C:\fakepath\error.JPG

hope you kind cooperation to resolve these errors.

I am using 1.11.1 openstudio and energyplus version is 8-5-0 my building consists of single story with attic, and i am not using ideal load or HVAC system, after I run the simulation i get 26 errors: 19 errors due to surface matching even the sketchup didn't show any errors after surface matching: ( i used matching tool and intersections for matching), however i noticed that all the errors are due to surface matching between the interior ceiling and the attic floor. C:\fakepath\2 error.JPG

and 7 other errors as shown in following figure: C:\fakepath\error.JPG

hope you kind cooperation to resolve these errors.