Hi! I'm trying to model a single zone building with OpenStudio. I'm trying to insert a HVAC system that works only with electricity. The type of system is not important to my study and I apreciate if you could advise the most appropriate one.I need to add the HVAC system because my study will be focused in the set of setpoints that gives the lowest HVAC energy cost.I added a Packadge Rooftop Heat Pump and attached to it my single thermal zone. The AVAC system is not working correctly. The "Coil heating DX single speed" and the "Coil Cooling DX single speed" presents electricity consumption when the interior temperature is between the cooling and heating setpoints. There are also situations where we can verify heating and cooling energy consumptions at the same time. My knowledge in HVAC system is far to be good and some help is needed. For this simple AVAC system do I have to add other(s) component(s) to the selected HVAC system or the HVAC template provided by OpenStudio is enough to my system works correctly? I appreciate if you could check my project to give me a clue for what I have to do to add the HVAC system correctly. Thank you

Hi! I'm trying to model a single zone building with OpenStudio. I'm trying to insert a HVAC system that works only with electricity. The type of system is not important to my study and I apreciate if you could advise the most appropriate one.I need to add the HVAC system because my study will be focused in the set of setpoints that gives the lowest HVAC energy cost.I added a Packadge Rooftop Heat Pump and attached to it my single thermal zone. The AVAC system is not working correctly. The "Coil heating DX single speed" and the "Coil Cooling DX single speed" presents electricity consumption when the interior temperature is between the cooling and heating setpoints. There are also situations where we can verify heating and cooling energy consumptions at the same time. My knowledge in HVAC system is far to be good and some help is needed. For this simple AVAC system do I have to add other(s) component(s) to the selected HVAC system or the HVAC template provided by OpenStudio is enough to my system works correctly? I appreciate if you could check my project to give me a clue for what I have to do to add the HVAC system correctly. Thank you

Hi! I'm trying to model a single zone building with OpenStudio. I'm trying to insert a HVAC system that works only with electricity. The type of system is not important to my study and I apreciate if you could advise the most appropriate one.I need to add the HVAC system because my study will be focused in the set of setpoints that gives the lowest HVAC energy cost.I added a Packadge Rooftop Heat Pump and attached to it my single thermal zone. The AVAC system is not working correctly. The "Coil heating DX single speed" and the "Coil Cooling DX single speed" presents electricity consumption when the interior temperature is between the cooling and heating setpoints. There are also situations where we can verify heating and cooling energy consumptions at the same time. My knowledge in HVAC system is far to be good and some help is needed. For this simple AVAC system do I have to add other(s) component(s) to the selected HVAC system or the HVAC template provided by OpenStudio is enough to my system works correctly? I appreciate if you could check my project to give me a clue for what I have to do to add the HVAC system correctly. Thank you