Error in Simulating the ZoneHVAC:LowTemperatureRadiant:VariableFlow (AutoSizing)

I am trying to simulate the ZoneHVAC:LowTemperatureRadiant:VariableFlow with autosizing on in OpenStudio. But getting this severe error "Hydronic radiant systems may not be autosized without specification of nodes or schedules" . Although , I have mentioned the both the nodes and schedules . I searched on net and found this thing "https://github.com/NREL/EnergyPlus/co..." but don't know how to use this and correct the source code of installed EnergyPlus and OpenStudio. Can anybody help me?

Engr.Samiullah's avatar
61
Engr.Samiullah
asked 2021-08-02 07:29:57 -0500
__AmirRoth__'s avatar
4.4k
__AmirRoth__
updated 2021-08-17 11:20:39 -0500
edit flag offensive 0 remove flag close merge delete

Comments

The bugfix you referenced addresses this bug, which says that it's only an issue for cooling-only radiant systems. Do you have a cooling-only radiant system?

shorowit's avatar shorowit (2021-08-03 11:59:52 -0500) edit
more
  • delete

Yes ; It is cooling-only radiant system

Engr.Samiullah's avatar Engr.Samiullah (2021-08-03 12:04:57 -0500) edit
more
  • delete

Perhaps you could work around the issue by adding heating, but disable the heating from being available/used?

shorowit's avatar shorowit (2021-08-03 12:07:54 -0500) edit
more
  • delete

For that , I have to specify the hot water loop . But I want to know direct solution of this bug.

Engr.Samiullah's avatar Engr.Samiullah (2021-08-03 12:17:48 -0500) edit
more
  • delete

Mr. Shorowit can you help me on this

Engr.Samiullah's avatar Engr.Samiullah (2021-08-14 11:53:46 -0500) edit
more
  • delete
add a comment see more comments