after changing the ceiling height the model got broken
Hi I was trying to changing the ceiling height by moving all the roof surface together
But after I selected the roof and move the edges , some of the points are still stay where they are before
\
I am following those steps shown in the video but got different results Did I miss any important steps ? https://www.youtube.com/watch?v=a8tNq... Thank you in advance
Comments
That video shows specialized case to move ceilings from multiple spaces at the same time. If you are just trying to do this for a single surface then try using SketchUp's push/pull tool on the roof surface, no selection of edges required.
Hi David thank you for this timely reply ! I was actually trying to move all the roof, but the inner spaces got problem. So I took screenshot of it. the outside surface are ok
Have you considered modelling that sloped surface as flat? Might make your life a lot easier.
thank you Jono, when I selected the edges and moved them, there are some points didn't get moved together for some reason. But later I moved them manually to other edges