Set-point manager in air loop (generic)

Hello all, I have a detailed system with an AHU with a cooling and heating coil serving one zone. I'm combining a Single Zone Heating and Single Zone Cooling Setpoint Managers for the generic air loop, but I'm not sure if this is the best set-point manager to use... if I employ the warmest setpoint manager the gas consumption decreases quite a bit. Would using either of the set point managers (i.e. a Single Zone Heating and Single Zone Cooling Setpoint Managers or only using the warmest) be correct? Also, I do not understand very well if I use the warmest setpoint manager how the heating is controlled. Thanks a lot!

The best way to model a system is to look at how it works in real life. Most rooftop units that serve a single zone have constant volume fans; therefore, the temperature of the air varies between a maximum and a minimum.

You can control your Airloop in this fashion using a SetpointManager:SingleZone:Reheat object. You will set your Minimum Supply Air Temperature and your Maximum Supply Air Temperature.

In your case, because you have a single zone system it does not make a difference to use the SetpointManager:Warmest to reset the supply air temperature, as there is only one zone and the SetpointManager:SingleZone:Reheat will also do that reset to accommodate your constant airflow.