Program exited before simulations began
I am performing a simulation for a residential building with 5 thermal zones. the simulation is good but when I'm changing the construction set, the following error appears :
Program Version,EnergyPlus, Version 9.0.1-bb7ca4f0da, YMD=2019.02.21 16:17, ************* Warning: Node connection errors not checked - most system input has not been read (see previous warning). ************* Fatal error -- final processing. Program exited before simulations began. See previous error messages. ************* EnergyPlus Warmup Error Summary. During Warmup: 0 Warning; 0 Severe Errors. ************* EnergyPlus Sizing Error Summary. During Sizing: 0 Warning; 0 Severe Errors. ************* EnergyPlus Terminated--Fatal Error Detected. 0 Warning; 0 Severe Errors; Elapsed Time=00hr 00min 0.19sec
Any help !!
Best Regard.
Comments
Are you running this input file directly in EP-Launch, or are you using an interface like OpenStudio to simulate the EnergyPlus model? Either way, you should have enough karma points to post a link to your .idf and your .audit files, which should be helpful to figure out what is wrong.
what warnings are in the .err file before this message?
Sir Aaron, yes i'm running the input file using EP-Launch.
Sir. Mdahlhausen, the .err file contains only the message above.
N.B. I'm using the EP-Launch version V9.0
Thanks a lot for your consideration.
@tassimo4.0 can you post a link to your .idf and .audit files? That will help to figure out what is wrong.
@AaronBoranian Please find attached the IDF file (this file is only used to estimate heating/cooling loads for a TMY in Oujda, Morocco). You can also find the associated .epw file. Cordially.
https://drive.google.com/drive/u/0/fo...