Design load with sizing factor is lower than Calculated design load [closed]

My Design Load With Sizing Factor is 33.14 tons which is lower than my Calculated Design Load of 48.69 tons. I didn't input a sizing factor for my zones so it should be using a default value of 1.15, correct? Why is this lower than the calculated design load? The air flows have a similar trend.

Closed for the following reason "the question is answered, right answer was accepted" by Saroop 2018-06-19 11:06:58 -0500

No, if blank or zero, the Zone Cooling (heating) Sizing Factor will be replaced by the global Sizing:Parameters.

By default the Sizing:Parameters sizing factors are 1.25 for heating and 1.15 for cooling (corresponding to ASHRAE Appendix G), but you may have changed them. These can be viewed/set on the "Simulation Settings" tab:

image description

29.7k

Julien Marrec

answered 2018-06-19 02:45:00 -0500

edit flag offensive 0 remove flag delete link

Comments

Thanks for the response. I didn't change the sizing factors in simulation settings, so they are using those values. 1.25 for heating and 1.15 for cooling. I now realized that I input a Cooling Design Air Flow Rate and that value is being for the sizing factor calculations.